[TPR] Distributor cleaned lubricated and the proper gear installed

[Owen Lee Green]

And it could all be contained on a single circuit board within the
distributor. Send the connection plug out the side or bottom.

On Fri, Jan 17, 2025, 5:02 PM Owen Lee Green <oneeyez4263 at gmail.com> wrote:

> I already see it in my head. I have been thinking about it for months.
>
> On Fri, Jan 17, 2025, 5:01 PM Owen Lee Green <oneeyez4263 at gmail.com>
> wrote:
>
>> You see the working of that idea don't you Jay.
>>
>> On Fri, Jan 17, 2025, 5:00 PM Asa Jay Laughton <asajay at asajay.com> wrote:
>>
>>> Dennis, put us in touch with a patent attorney.
>>>
>>> Asa  Jay
>>> Sent via radio waves
>>>
>>> On Jan 17, 2025, at 16:48, Owen Lee Green <oneeyez4263 at gmail.com> wrote:
>>>
>>> 
>>>
>>> That's why 2 sets narrow under the wides. Plus the spark pickups are
>>> just wide enough to enhance the spark induction so that there are several
>>> degrees of spark the system would require a 18 or 20 pin lead system to a
>>> controller unit that would allow for individual coil packs to each
>>> cylinder. Or a single coil.
>>>
>>> On Fri, Jan 17, 2025, 4:43 PM Asa Jay Laughton <asajay at asajay.com>
>>> wrote:
>>>
>>>> That is nearly brilliant.  Some details to work out there though.  It
>>>> needs a little bit of smarts to parse the small pulses from the big to make
>>>> sure either the spark plug is triggered or the fuel injector.
>>>>
>>>> Asa  Jay
>>>> Sent via radio waves
>>>>
>>>> On Jan 17, 2025, at 16:34, Owen Lee Green via TPR <
>>>> tpr at teampanteraracing.com> wrote:
>>>>
>>>> 
>>>>
>>>> Have an idea for a redesign for distributors. 16 magnetic pickups,8
>>>> narrow and 8 wide pickups. Then the narrow ones for spark the wide ones for
>>>> fuel injectors in sequence with a single tooth reluctor on the shaft.
>>>> Control spark and fuel injectors on one drop in distributor. And the setup
>>>> would work for any engine out there, no matter who's engine it goes into.
>>>>
>>>> On Fri, Jan 17, 2025, 3:43 PM DENNIS ANTENUCCI via TPR <
>>>> tpr at teampanteraracing.com> wrote:
>>>>
>>>>> NICE!
>>>>> Of course I have IR-EFI
>>>>> Haja
>>>>>
>>>>> Dennis
>>>>> Sent from my iPhone
>>>>>
>>>>> > On Jan 17, 2025, at 2:03 PM, Lee Pedersen via TPR <
>>>>> tpr at teampanteraracing.com> wrote:
>>>>> >
>>>>> > 
>>>>> > <IMG_20250116_153956931_MF_PORTRAIT.jpg>
>>>>> >
>>>>> > Tpp
>>>>> >
>>>>> > It was from a 1978 Ford bronco 351M distributor allows for dura
>>>>> spark ignition which is probably the best you could hope for even Hall said
>>>>> that when he was alive. I ran it it ran well but the distributor gear
>>>>> itself has the hole in a different place than a 351 Cleveland distributor
>>>>> so took a little while to figure that out. Iski cams said run the stock
>>>>> gear on their cam so it's back on
>>>>> > <IMG_20250116_153956931_MF_PORTRAIT.jpg>
>>>>> > _______________________________________________
>>>>> > TPR mailing list
>>>>> > TPR at teampanteraracing.com
>>>>> >
>>>>> http://teampanteraracing.com/mailman/listinfo/tpr_teampanteraracing.com
>>>>>
>>>>>
>>>>> _______________________________________________
>>>>> TPR mailing list
>>>>> TPR at teampanteraracing.com
>>>>> http://teampanteraracing.com/mailman/listinfo/tpr_teampanteraracing.com
>>>>>
>>>> _______________________________________________
>>>> TPR mailing list
>>>> TPR at teampanteraracing.com
>>>> http://teampanteraracing.com/mailman/listinfo/tpr_teampanteraracing.com
>>>>
>>>>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://teampanteraracing.com/pipermail/tpr_teampanteraracing.com/attachments/20250117/31e4361c/attachment-0002.html>