[TPR] Distributor cleaned lubricated and the proper gear installed

[Owen Lee Green]

And it would be movable to adapt for advance abilities.

On Fri, Jan 17, 2025, 5:04 PM Owen Lee Green <oneeyez4263 at gmail.com> wrote:

> And it could all be contained on a single circuit board within the
> distributor. Send the connection plug out the side or bottom.
>
> On Fri, Jan 17, 2025, 5:02 PM Owen Lee Green <oneeyez4263 at gmail.com>
> wrote:
>
>> I already see it in my head. I have been thinking about it for months.
>>
>> On Fri, Jan 17, 2025, 5:01 PM Owen Lee Green <oneeyez4263 at gmail.com>
>> wrote:
>>
>>> You see the working of that idea don't you Jay.
>>>
>>> On Fri, Jan 17, 2025, 5:00 PM Asa Jay Laughton <asajay at asajay.com>
>>> wrote:
>>>
>>>> Dennis, put us in touch with a patent attorney.
>>>>
>>>> Asa  Jay
>>>> Sent via radio waves
>>>>
>>>> On Jan 17, 2025, at 16:48, Owen Lee Green <oneeyez4263 at gmail.com>
>>>> wrote:
>>>>
>>>> 
>>>>
>>>> That's why 2 sets narrow under the wides. Plus the spark pickups are
>>>> just wide enough to enhance the spark induction so that there are several
>>>> degrees of spark the system would require a 18 or 20 pin lead system to a
>>>> controller unit that would allow for individual coil packs to each
>>>> cylinder. Or a single coil.
>>>>
>>>> On Fri, Jan 17, 2025, 4:43 PM Asa Jay Laughton <asajay at asajay.com>
>>>> wrote:
>>>>
>>>>> That is nearly brilliant.  Some details to work out there though.  It
>>>>> needs a little bit of smarts to parse the small pulses from the big to make
>>>>> sure either the spark plug is triggered or the fuel injector.
>>>>>
>>>>> Asa  Jay
>>>>> Sent via radio waves
>>>>>
>>>>> On Jan 17, 2025, at 16:34, Owen Lee Green via TPR <
>>>>> tpr at teampanteraracing.com> wrote:
>>>>>
>>>>> 
>>>>>
>>>>> Have an idea for a redesign for distributors. 16 magnetic pickups,8
>>>>> narrow and 8 wide pickups. Then the narrow ones for spark the wide ones for
>>>>> fuel injectors in sequence with a single tooth reluctor on the shaft.
>>>>> Control spark and fuel injectors on one drop in distributor. And the setup
>>>>> would work for any engine out there, no matter who's engine it goes into.
>>>>>
>>>>> On Fri, Jan 17, 2025, 3:43 PM DENNIS ANTENUCCI via TPR <
>>>>> tpr at teampanteraracing.com> wrote:
>>>>>
>>>>>> NICE!
>>>>>> Of course I have IR-EFI
>>>>>> Haja
>>>>>>
>>>>>> Dennis
>>>>>> Sent from my iPhone
>>>>>>
>>>>>> > On Jan 17, 2025, at 2:03 PM, Lee Pedersen via TPR <
>>>>>> tpr at teampanteraracing.com> wrote:
>>>>>> >
>>>>>> > 
>>>>>> > <IMG_20250116_153956931_MF_PORTRAIT.jpg>
>>>>>> >
>>>>>> > Tpp
>>>>>> >
>>>>>> > It was from a 1978 Ford bronco 351M distributor allows for dura
>>>>>> spark ignition which is probably the best you could hope for even Hall said
>>>>>> that when he was alive. I ran it it ran well but the distributor gear
>>>>>> itself has the hole in a different place than a 351 Cleveland distributor
>>>>>> so took a little while to figure that out. Iski cams said run the stock
>>>>>> gear on their cam so it's back on
>>>>>> > <IMG_20250116_153956931_MF_PORTRAIT.jpg>
>>>>>> > _______________________________________________
>>>>>> > TPR mailing list
>>>>>> > TPR at teampanteraracing.com
>>>>>> >
>>>>>> http://teampanteraracing.com/mailman/listinfo/tpr_teampanteraracing.com
>>>>>>
>>>>>>
>>>>>> _______________________________________________
>>>>>> TPR mailing list
>>>>>> TPR at teampanteraracing.com
>>>>>>
>>>>>> http://teampanteraracing.com/mailman/listinfo/tpr_teampanteraracing.com
>>>>>>
>>>>> _______________________________________________
>>>>> TPR mailing list
>>>>> TPR at teampanteraracing.com
>>>>> http://teampanteraracing.com/mailman/listinfo/tpr_teampanteraracing.com
>>>>>
>>>>>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://teampanteraracing.com/pipermail/tpr_teampanteraracing.com/attachments/20250117/df56fbc5/attachment-0002.html>