[TPR] Grommet (near wiper motor) for wire loom to car front

[Asa Jay Laughton]

Nicely done. :)

Asa Jay

Asa Jay Laughton, MSgt, USAFR, Retired
&  Shelley Marie
Spokane, WA
******************************
http://www.racingagainstautism.com
http://www.teampanteraracing.com
http://facebook.com/racingagainstautism


On 7/18/2012 6:58 PM, B Hower wrote:
> FWIW:
> I found that a Chrysler PCV grommet ( O'Reilly # 42344 ) will fit the 
> wire loom ( that feeds front of car ) and it's hole. Just cut out 3/8" 
> at OD to 1/4" at ID. The inside of hole lip is smaller than the 
> outside of hole lip making installation easier. I than chose to apply 
> a little silicone at grommet OD and cut for added sealing.
> Bud #3400
>
>
> _______________________________________________
> TPR mailing list
> TPR at teampanteraracing.com
> http://lists.teampanteraracing.com/cgi-bin/mailman/listinfo/tpr
>
>
> No virus found in this message.
> Checked by AVG - www.avg.com <http://www.avg.com>
> Version: 10.0.1424 / Virus Database: 2437/5140 - Release Date: 07/18/12
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://teampanteraracing.com/pipermail/tpr_teampanteraracing.com/attachments/20120718/db9899e6/attachment-0003.html>