[TPR] Checking the specs,Asa's current Mach I engine

[russell fulp]

Well in response to your question about rings  (The cylinders still show cross-hatching, even so I had planned on 
> borrowing a ball hone to run in the holes prior to assembly. The 
> rings still have gobs of tension. I hate to spend even more money I The piston rings you would need for your econo-build would only cost you about  $ 60.00  Or less !
> hadn't budgeted, on rings. What's the downside of using them again? If you install the rings in the same cylinder they came out of. Providing they were sealed then!! would be O.K. 
> Especially if they didn't seat the first time?
> 
> ... and further to that question, what rings would you recommend?) I would just use a Speed- Pro pregapped ring # E251K which is a moly ring
> 
I'm not trying to tell you what to do , Asa just suggesting strongly by what I have run across 

Russ
B.L. Machine & Russ Fulp Race Engines
1100 E. Orangefair Lane Unit E            
Anaheim, Ca. 92801
714-870-8570

  		 	   		  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://teampanteraracing.com/pipermail/tpr_teampanteraracing.com/attachments/20120705/1eb4169a/attachment-0003.html>